AN-428 Analog I/O resolution change for Flexslices

AN-428 Analog I/O resolution change for Flexslices

This application note explains how to change the range for Voltage signal on the Flexslice module:

The P378 & P379 has Signal Voltage option of
1) -5V to +5V
2) -10V to +10V
3) 0V to 5V
4) 0V to 10V

    • Related Articles

    • virtual output

      Q: How do I used a virtual output? How can I read the state of the virtual output? A: Set virtual output with OP. Read virtual output with IN. OP(24,ON) IF IN(24)=ON THEN PRINT "OK" ENDIF

    • Flexslice 24V digital input levels

      The P372 PNP 16 x Digital Input module has input threshold values to work with standard PLC IO systems.  If the input is below 5V then the input is OFF.  If the input is above 15V then the input will register as ON.

    • Do Motion Coordinators have exernal digital and analogue I/O for each axis?

      The internal and external I/O is flexible.  Any axis can use any Input as home, limit switch and feedhold inputs.  While the servo loops must use the on-board analogue outputs for servo drive control, the external ADC input modules may be used for ...

    • AN-411 CAN P329 Intro Guide

      Trio CAN 16-IN 16-OUT modules allow I/O expansion for the CAN enabled Trio Motion Coordinators. The P329 module fits in the existing Trio CAN range, providing a single module with 16 digital inputs and 16 digital outputs. This document describes ...

    • Analog incremental linear encoder input to Trio

      We are looking to retrofit a Trio controller to a 3 axis CNC machine which has heidenhain analog incremental linear encoders fitted (1Vpp - 40um linear period) but unsure which if any controller has this function available. Can you advise please - ...