Flexslice 24V digital input levels

Flexslice 24V digital input levels

The P372 PNP 16 x Digital Input module has input threshold values to work with standard PLC IO systems.  If the input is below 5V then the input is OFF.  If the input is above 15V then the input will register as ON.

    • Related Articles

    • Flexslice Loading/Configuration Limits - EBUS Load

      EBUS loading of the the Flex-6 Nano and the Flex Coupler (P366) is limited to 16. Attached is a spreadsheet to calculate your projects requirements and highlight any possible limitations.

    • Wire size for Flexslice I/O modules

      Trio's Flexslice modules use the a 10-way 3.5mm pitch, push fit connector: 15EDGKN-3.5-10P-13 from Degson. According to the manufacturer's datasheets (https://www.tme.eu/Document/580c900c7460c0af0ff973aec46ec4f5/15edgk.pdf) the maximum wire size is ...

    • What is the ouput current of the 24V digital ouputs on DX4 drives?

      The Digital Outputs of the DX4 drive have a maximum current capability of 30mA. Digital inputs have current limit resistors and are rated at 24V, max load less than 10mA. The ED3S (Summa) drive and the DX4 have the same range.

    • Do Motion Coordinators have exernal digital and analogue I/O for each axis?

      The internal and external I/O is flexible.  Any axis can use any Input as home, limit switch and feedhold inputs.  While the servo loops must use the on-board analogue outputs for servo drive control, the external ADC input modules may be used for ...

    • AN-411 CAN P329 Intro Guide

      Trio CAN 16-IN 16-OUT modules allow I/O expansion for the CAN enabled Trio Motion Coordinators. The P329 module fits in the existing Trio CAN range, providing a single module with 16 digital inputs and 16 digital outputs. This document describes ...