Setting up Balluff IO-Link device

AN-404 How to Setup Balluff IO-Link device with Trio

The Balluff BNI 0077 EtherCAT to IO-Link bridge requires a setup profile that configures it for the IO-Link devices connected. A Trio EtherCAT master uses an ENI type file called EC_EXTEND to allow such configuration.

This document explains how to configure this device.

    • Related Articles

    • AN-379 Editing EC_EXTEND file

      EC_EXTEND files contain configuration information to allow the Motion Coordinator to start an EtherCAT slave node. It is used when the slave node information is not in the Motion Coordinator’s firmware database, or if a specific PDO configuration is ...

    • EC_EXTEND for SMC JXCE1

      Trio have helped to set up the JXCE1 before. It is not a standard axis as far as the controller is concerned so if you look at the attached EC_EXTEND you will see that all the objects are mapped to VRs and so you must look at the manual and see what ...

    • DX4 PDO Working with Trio Basic Commands

      Customers have the ability to create modified EC_EXTEND files for the Trio DX4 in Motion Perfect 5. This is accessible in the DX4 Drive Network Configuration with the option to configure Custom Profiles. Please see ATTACHMENT tab for further ...

    • AN-315 EtherCAT setup for Panasonic A5B Drive

      When delivered, the Panasonic A5B has 2 features set; the Positive Over Travel Input (POT) and the Negative Over Travel input (NOT). If these are connected to limit switches then the system will work in the usual way until the limit switch is ...

    • AN-427 VIPA 053-EC01 IO coupler - How to add slave devices using EC_EXTEND

      This document explains how to add slave devices on VIPA coupler 053-EC01