AN-384 Conversion from P315/316 to P319 Trio CAN I/O Module
The P319 is the new replacement for the P315 and P316 CANbus IO modules from Trio.
This document lists the compatibility and differences between the older modules and the new P319.
Related Articles
Could not restart CANIO with CANIO_STATUS
CAN IO modules went into error and could not be reset by CANIO_STATUS.4 = 1. After some tests, the customer found the issue was as follows: It was solved by providing isolation for Trio and Can IO module from the panel. Also used separate 24V supply ...
Trio Scara Motor & Drive Sizes
Trio Scara Motor & Drive Sizes Drop Files to Attach
AN-358 Conversion from Old Trio Keypad to UNIPLAY HMI
Systems using the P502 and P503 vacuum-fluorescent keypads can be updated to use the Trio 7 inch or 10 inch HMI. (P845 and P846) This document explains how to convert from this old keypads to the UNIPLAY HMI There are options to either use a ...
CANbus port check
MC403, MC405, Euro404 and Euro408 Motion Coordinators that appear to have a failed CANbus port. Check that the CANIO_ADDRESS is set to 32 when using Trio CANIO mode or to 40 .. 42 when using CanOpen. The CANIO_ADDRESS is stored in Flash in the above ...
Setting up Profinet connection with Trio Controllers
Requirement Minimum firmware version of 2.0319. Supporting Documents See the attached zipped file (dist.zip) for the following supporting files: Application Note AN-449 TRIO Controllers with Profinet Motion Perfect project sample GSD file: ...