AN-383 EtherCAT Drive connection guide

• Related Articles

• Changing EtherCAT drive address

  There are 3 methods to set the address in the servo-drive; 1 . If there are rotary address switches on the front of the drive, then they may be used to select the address. 2. The address may be set in memory, either via a front panel keypad or ...

• AN-315 EtherCAT setup for Panasonic A5B Drive

  When delivered, the Panasonic A5B has 2 features set; the Positive Over Travel Input (POT) and the Negative Over Travel input (NOT). If these are connected to limit switches then the system will work in the usual way until the limit switch is ...

• MC_CONFIG vs Flash parameters

  All Motion Coordinators store the IP_ADDRESS, IP_NETMASK and IP_GATEWAY in Flash memory.  So there is usually no need to add them to the MC_CONFIG. There are some differences with other system parameters. MC4N-ECAT, MC4N-RTX, MC6N-ECAT, Flex-6 Nano ...

• EtherCAT start - diagnostic information

  When reporting an EtherCAT startup error, please send the following information to Trio technical support. 1) The text shown on the terminal after ETHERCAT(0, 0) For example: >>ETHERCAT(0,0) Warning - EtherCAT cable or network not detected (slot 0). ...

• MC202 controller and Motion Perfect

  For the MC202 you must use Motion Perfect 2. Motion Perfect versions 3, 4 and 5 are for the later generation of Motion Coordinators that connect using Ethernet. I am running this version of Motion perfect 2 on my Windows 10 PC. You need a COM port on ...