AN-288 P874 with Jacquard Interface

AN-288 P874 with Jacquard Interface

This document provides information on using a P874 with a custom programmed FPGA allowing control of a Jacquard distribution board via SPI over an RS422 physical layer. Software enhancements are also described which allow a data file to be transmitted to the controller in compressed (Zipped) format and stored on a Motion Coordinator in this format.

    • Related Articles

    • AN-376 P230 & P240 Daughter Stepper Board upgrade guide

      The P230 and P240 daughter boards were used in the MC1, MC2 and MC2xx ranges of Motion Coordinator. Sometimes a machine requires an upgrade and conversion to use the latest range of Trio Motion Coordinator. This document covers the main differences ...

    • Serial ports on PC-MCAT for Motion Coordinator Channels

      The PC-MCAT API brings channels 1 and 2 out into the API, but does not map them to anything.  The attached little program is an example which will do that for you. It is a 7z folder encrypted with password abc123. A USB to RS232 converter will be ...

    • Establishing eCAT connection with Trio and Bosch Rexroth Driver HSC01

      For Bosch Rexroth Drive, the PDO's have to be written to the drive memory through TrioBASIC program in Pre-op. If not the drive will not switch from Pre-OP --> Safe-OP. You will require a program & EC_EXTEND file (included in the attachment) Use the ...

    • Enquiry about Endat interface using Bekchoff EL5032

      EC_EXTEND for Beckhoff EL5032 2 x Encoder input module. Tested and working on 28th January 2020. The EK1100 coupler is already in the firmware. It does not require an EC_EXTEND.

    • MC403 encoder power overload

      Issue: The 5 volt supply is taken from an axis port of the MC403 and cable length is >15 meters. After 15-20 days the power supply overloaded alarms comes. After removing and reconnecting the cable, the alarm went away. But after 2-3 days alarm came ...