Euro205x (P156) vs Euro404 (P832)

Euro205x (P156) vs Euro404 (P832)

The Euro404 is the nearest new product to the P156.  However it is not fully pin compatible.  Please see the application note AN-334 in the knowledge base here. AN-334 Conversion from EURO205x to EURO 404/408

    • Related Articles

    • Replace EURO205X with EURO209

      The Euro 209 and Euro 404/408 share the same pinout arrangement which is somewhat different to the Euro 205(x). So changing from 205 to either the 404 or 408 will have the same hardware challenges. Software wise the 205/404 difference is similar to ...

    • UNITs vs Arcs question

      In and XY motion system, if you make only linear lines, it does not matter if X and Y UNITS are not the same. But the MOVECIRC and MHELICAL must have the UNITS on X then same as UNITS on Y, otherwise they produce elipses and not circular arcs. The ...

    • AN-334 Conversion from EURO205x to EURO 404/408

      The Euro 404/408 is the closest controller in the MC4 range to the performance and functionality of the Euro 205X. This document gives the answers to the most asked questions about the upgrade path from Euro 205X to the new Euro 404/408.

    • MC_CONFIG vs Flash parameters

      All Motion Coordinators store the IP_ADDRESS, IP_NETMASK and IP_GATEWAY in Flash memory.  So there is usually no need to add them to the MC_CONFIG. There are some differences with other system parameters. MC4N-ECAT, MC4N-RTX, MC6N-ECAT, Flex-6 Nano ...

    • MC224 Control Technic with SLM-Card VS MC664

      MC664 in theory can support the P873 though we do not at present have any customers using that combination. The P873 will support 6 axes (2 x 3). You do not need feature codes, the axes are included in the price. There was no special build of MC224 ...