Converting MC302x to MC403

AN-390 Conversion from MC302x to MC403

The MC302X went out of production during 2008. The nearest modern product which can be used as a replacement is the MC403. However there are some significant detail differences between these 2 Motion Coordinators.

This document explains the differences and programming considerations when you are converting a MC302x to MC403

    • Related Articles

    • MC_CONFIG vs Flash parameters

      All Motion Coordinators store the IP_ADDRESS, IP_NETMASK and IP_GATEWAY in Flash memory.  So there is usually no need to add them to the MC_CONFIG. There are some differences with other system parameters. MC4N-ECAT, MC4N-RTX, MC6N-ECAT, Flex-6 Nano ...

    • Motion Perfect problem when SCOPE command is used

      When running the SCOPE command in a program, I think Motion Perfect doesn't like the SCOPE command being issued over and over when I run it. It seems more stable when I comment the SCOPE command out after it's ran once. ...

    • MC202 controller and Motion Perfect

      For the MC202 you must use Motion Perfect 2. Motion Perfect versions 3, 4 and 5 are for the later generation of Motion Coordinators that connect using Ethernet. I am running this version of Motion perfect 2 on my Windows 10 PC. You need a COM port on ...

    • Can I use Motion Perfect v4 with the new MC404-Z?

      The MC404-Z and other new products require the latest version of Motion Perfect to run them.  At the time of writing this post, the latest version is MPv5 version 5.0.2 and that is the recommended version for programming the MC404-Z 4 axis stepper ...

    • Will processes change with Motion Perfect 5?

      Process numbering is controlled entirely by the firmware so nothing should change when you update Motion Perfect.  For example, process numbers for MC405 are 0 to 9.