P375 Stepper Axis connection guide

AN-380 P375 Connection Guide & Setup

This document explains how to connect & setup a P375 Stepper Axis Flexslice module 

Updated
    • Related Articles

    • Flexaxis 4/8 Encoder Setup

      When connecting Encoders or using the analogue outputs on the P879 and P874 Felxaxis modules with the MC464 or MC664(X), the Flexaxis Module must have 24V connected to the IO connector on the Module. The 24V supplies internal DC/DC converters for the ...
    • AN-383 EtherCAT Drive connection guide

      This document explains how to connect Trio controller via EtherCAT
    • AN-363 MODBUS RTU connecting to Stepper Drive

      This document is a guide to users wanting to use the Motion Coordinator MC4/5/6 as a Modbus master connected to a typical slave device. The actual example used is the Moons ST stepper drive.
    • AN-315 EtherCAT setup for Panasonic A5B Drive

      The recommendations within this document applies to the Trio MC464+P876 EtherCAT master and the Trio MC4N-ECAT EtherCAT Master used with the Panasonic Minas A5B EtherCAT servo drive. When delivered, the Panasonic A5B has 2 features set; the Positive ...
    • AN-315 EtherCAT setup for Panasonic A5B Drive

      When delivered, the Panasonic A5B has 2 features set; the Positive Over Travel Input (POT) and the Negative Over Travel input (NOT). If these are connected to limit switches then the system will work in the usual way until the limit switch is ...