AN-333 BiSS Encoder support

AN-333 BiSS Encoder support

A BiSS implementation has been added to some Trio controllers to support reading of encoder position from devices fitted with a BiSS interface. 

This document explains how to integrate BiSS encoder to Trio

    • Related Articles

    • MC508 Absolute encoder support

      Absolute encoder support was added recently in firmware  2.0298 + FPGA version 0A.   Axes 0 to 7 will support SSI, BiSS and EnDAT Axis 8 will support SSI, BiSS and Tamagawa Axes 9 to 15 are still stepper only

    • Does the Euro408 have incremental/absolute encoder feedback ?

      The Euro404 and Euro408 support the following encoder types: Incremental ABZ with differential RS422 line driver outputs. (A, /A, B, /B, Z, /Z) SSI Absolute encoder up to 32 bits. EnDat Absolute encoder either EnDat 1 or EnDat 2.  The EnDat 2 support ...

    • Analog incremental linear encoder input to Trio

      We are looking to retrofit a Trio controller to a 3 axis CNC machine which has heidenhain analog incremental linear encoders fitted (1Vpp - 40um linear period) but unsure which if any controller has this function available. Can you advise please - ...

    • DX4 Encoder Resolution / Scaling

      This option is available through the Parameters Pn725 and Pn726 and the values used will depend on the type of encoder you have on the motor (20 or 23bit). Section 9-11 has some descriptions in the manual.

    • Connection to Single Ended Encoder (Incremental/Absolute)

      It is not recommended to connect an encoder single ended because it creates strange counting behavior due to signal noise and level drifts. TTL output uses differential wiring (A with /A and B with /B) to cancel noise. But... If single ended encoders ...