What is the range of Servo update rates on P834 EURO408?

• Related Articles

• Setting PLC cycle time

  To set the cycle time of the virual PLC in an IEC 61131-3 task, first stop the task and right click the task name in the control panel. Then click on the Execution Mode tab. The fastest cycle time that can be set is 1 msec if the IEC task is run on a ...

• EURO 404 - Motion Problem at SERVO_PERIOD 250

  A motion problem could occur when running MC403, MC405, Euro404 or Euro408 at 250 usec servo period. The moves would stop (buffers frozen) and an uncommanded movment could occur on one axis in an XY pair. The issue occured very infrequently and was ...

• Kollmorgen drive with SERVO_PERIOD issue

  EtherCAT network goes in operational state only with SERVO_PERIOD=250 µsec setting when Kollmorgen drives are in use. The network stays in safe-operational state with any other servo period setting. The following needs to be done; * MC_CONFIG to be ...

• What does SERVO_OFFSET do?

  SERVO_OFFSET is a system parameter that is usually set by the operating system.  The value depends on the SERVO_PERIOD, the modules fitted (to a MC664X) and the model of Motion Coordinator.  It should not be necessary to set this in a system.  Only ...

• MC6N Recovery

  The MC6N has a recovery method if the firmware does not boot. Follow section 9.2 from Application note: AN282