What is the ouput current of the 24V digital ouputs on DX4 drives?

What is the ouput current of the 24V digital ouputs on DX4 drives?

The Digital Outputs of the DX4 drive have a maximum current capability of 30mA.

Digital inputs have current limit resistors and are rated at 24V, max load less than 10mA.

The ED3S (Summa) drive and the DX4 have the same range.


    • Related Articles

    • Flexslice 24V digital input levels

      The P372 PNP 16 x Digital Input module has input threshold values to work with standard PLC IO systems.  If the input is below 5V then the input is OFF.  If the input is above 15V then the input will register as ON.
    • AN-316 CANOpen IO Setup Guide

      There are 2 modes of CAN operation available: 1. Trio CANbus protocol. This is the default protocol and is tailored for the high performance Input/Output needed in a Motion System. 2. CanOpen to Can in Automation standards CiA301 and CiA401. Option 2 ...
    • A Trio BASIC Function Library for calculating min, max and average

      The attached library has 10 functions; result = compare_2(v1, v2) preset_max(index, value) preset_min(index, value) compare_max(index, value) compare_min(index, value) value = read_max_register(index) value = read_min_register(index) And for the ...
    • AN-411 CAN P329 Intro Guide

      Trio CAN 16-IN 16-OUT modules allow I/O expansion for the CAN enabled Trio Motion Coordinators. The P329 module fits in the existing Trio CAN range, providing a single module with 16 digital inputs and 16 digital outputs. This document describes ...
    • Do Motion Coordinators have exernal digital and analogue I/O for each axis?

      The internal and external I/O is flexible.  Any axis can use any Input as home, limit switch and feedhold inputs.  While the servo loops must use the on-board analogue outputs for servo drive control, the external ADC input modules may be used for ...