Rolling back firmware on Flex-6 Nano
Q. Since we’ve updated to v2.0322 there have been issues noticed on our rigs and immediately they are wondering if the TRIO firmware update might be to blame as nothing else changed.
Is it possible to roll back the TRIO firmware from v2.0322 to v2.309?
I’m guessing not as there was a bootloader change somewhere in between those versions, but asking just in case.
A. Yes you can roll back. The updated boot loader is protected and will remain in place.
Related Articles
Flex Nano not connecting to EtherCAT or HMI (E09 Error)
Please confirm that the firmware has been upgraded to 2.0318 or later with Bootloader V2.05 according to the technical bulletin. TB2202_Flex-6 and MC6N update. The Bulletin was distributed on 9th December 2022. After installing the update, the old ...
AN-356 Firmware update procedure for UNIPLAY HMI
Uniplay 10' (P844) Human Machine Interface may be returned to us with corruption of the Flash that either causes the system to halt or prevents booting altogether. It is also possible if an update has not been interrupted or was not successful that ...
MC6N Recovery
The MC6N has a recovery method if the firmware does not boot. Follow section 9.2 from Application note: AN282
AN-342 Error during loading firmware
When installing a new firmware version, the process has two main steps. Firstly, the firmware file is downloaded on to the RAM memory and after that, the firmware is installed from RAM into the flash memory. If for any reason the power from the ...
AN-399 TrioPC Motion Performance with Flex-6 Nano
This document describes some timing tests with made with TrioPC motion Active X and Flex-6 Nano Motion Coordinator.