P375 card with F6NANO

P375 card with F6NANO

I'm trying to use a P375  card with 3 embedded stepper axes.

P375 flexsice serial number is  P375-00096.  It was bought in London from a reseller.
I have tried to drive it with the Flex-6 Nano without success. 

==============================================================================
Answer:
The P375 Flexslice 3 axis Module has 4 hardware revisions.

Revision 1: P375-00001 to P375-00074: Prototypes only – fixed function stepper outputs only.
Revision 2: P375-00075 to P375-00099: Stepper and Encoder, no touch probe registration.
Revision 3: P375-00100 to P375-00174: Stepper and Encoder including Registration capability.
Revision 4: P375-00175 and later: Stepper, Encoder, Registration.  Absolute encoder ready. 

As these have different hardware, it is not possible to upgrade any revision to a higher level.  Only Revision 4 is supported by the latest firmware in our Motion Coordinators.

    • Related Articles

    • P375 card with 3 stepper - MPOS and DPOS in error

      Even with open loop stepper, the P375 has an encoder counter that counts the pulses and sends them back to the controller so that we can do registration. The feedback is in pulse counts but DPOS is in counts x 256. Therefore it is necessary to set ...
    • Loading encrypted project from SD card

      This is the content for the SD card TRIOINIT.BAS ' *** ' SD Card decryption demo. ' Prepared by Trio Motion Technology Ltd. ' ' *** PROJECT_KEY "O5/A6qXkaXc" FILE "LOAD_PROJECT" "training ecr1" Replace the key above with yours and use your project ...
    • AN-363 MODBUS RTU connecting to Stepper Drive

      This document is a guide to users wanting to use the Motion Coordinator MC4/5/6 as a Modbus master connected to a typical slave device. The actual example used is the Moons ST stepper drive.
    • AN-376 P230 & P240 Daughter Stepper Board upgrade guide

      The P230 and P240 daughter boards were used in the MC1, MC2 and MC2xx ranges of Motion Coordinator. Sometimes a machine requires an upgrade and conversion to use the latest range of Trio Motion Coordinator. This document covers the main differences ...
    • AN-408 Using SD card to change IP Address

      This document explains how to change the IP address, subnet mask and default gateway by using a SD card or micro SD card on Trio Motion Coordinator