Few questions regarding Motion Perfect

Few questions regarding Motion Perfect

If you want to do the same as the Motion Stop button in Motion Perfect then this is the command list done by Motion Stop:

RAPIDSTOP(2)
HALT
WDOG=0

That stops all axes, stops all programs and disables the drives.

    • Related Articles

    • Will processes change with Motion Perfect 5?

      Process numbering is controlled entirely by the firmware so nothing should change when you update Motion Perfect.  For example, process numbers for MC405 are 0 to 9.

    • MC202 controller and Motion Perfect

      For the MC202 you must use Motion Perfect 2. Motion Perfect versions 3, 4 and 5 are for the later generation of Motion Coordinators that connect using Ethernet. I am running this version of Motion perfect 2 on my Windows 10 PC. You need a COM port on ...

    • Can I use Motion Perfect v4 with the new MC404-Z?

      The MC404-Z and other new products require the latest version of Motion Perfect to run them.  At the time of writing this post, the latest version is MPv5 version 5.0.2 and that is the recommended version for programming the MC404-Z 4 axis stepper ...

    • Motion Perfect problem when SCOPE command is used

      When running the SCOPE command in a program, I think Motion Perfect doesn't like the SCOPE command being issued over and over when I run it. It seems more stable when I comment the SCOPE command out after it's ran once. ...

    • Can I run motion perfect 4.4.1 on Windows 11?

      We can run Windows 11 with both MP v4.4.1 and MP v5.2.1 Trio have tested the HMI simulator 1.30.1.1935 which comes with 4.4.1 and it works OK. We also tested the HMI simulator 2.1.2.1874 which is with the next upcoming 5.2.2 release and that is also ...