DX4 Filter Recommendation

To comply with the limits based on IEC/EN 61800-3 second environment (C2) the Drive and Motor must be installed with an EMC/RFI filter.

Recommended filters are:

These filters have been tested with cable lengths of 3m and 20m.

• Related Articles

• Encoder MSPEED

  The MSPEED is sampled per servo cycle. So typically it is number of counts per millisecond. At slow speed there can be less than one count per msec. So it goes 0, then 1 then 0 etc. That is then multiplied by UNITS so the effect seems to be ...

• Connection to Single Ended Encoder (Incremental/Absolute)

  It is not recommended to connect an encoder single ended because it creates strange counting behavior due to signal noise and level drifts. TTL output uses differential wiring (A with /A and B with /B) to cancel noise. But... If single ended encoders ...

• CAN IO Address Problem

  The Leds on the module are a binary code. LEDs 8, 9 and 10 ON woud be code 7 = System Shutdown. Usually this is caused by interference on the CAN lines. Check the correct screened cable has been used and that both ends are terminated with 120 Ohm ...

• Jitter on the direction output, MC403-Z P821

  When using a MC403-Z P821, we are facing with an issue related to the "direction" signal. Please take a look at the following picture: Scope screen We have connected the oscilloscope on the step signal (channel 1) and direction signal (channel 2). ...