AN-365 TrioPCMotion ActiveX Heartbeat

• Related Articles

• TrioPCMotion will not connect

  For an MC403, MC405 or MC464 that refuses to allow a TrioPCMotion ActiveX connection, check that the REMOTE program is not disabled in the flash memory. Look at the value in REMOTE_PROC. It is a system parameter that is stored in Flash in the MC403, ...

• AN-419 TrioPCMotion TCP port

  Motion Coordinator firmware version 2.0300 has the ability to open a TCP server port on Ethernet. This document describes a program that can be run in Visual Basic to communicate with the Motion Coordinator. Requires TrioPC Motion ActiveX V2.20.5 or ...

• Axis Status Error

  Just picked up my Flex-6 Nano again to do some testing with movelink, for some reason my FLEX-3AX is throwing errors. pressing the error reset button is not changing anything. All 3 axis are the same: Answer: The Fault bit in the CoE status will be ...

• AN-304 Adding TrioPC to Visual Basic

  A connection between a Windows PC and a Motion Coordinator can be made with an ActiveX component called TrioPC Motion. The ActiveX component must be added to the Visual Basic project. This document describes this step by step. The example is based on ...

• DRIVE_STATUS issue (EtherCAT CoE status word)

  DRIVE_STATUS is the value of the CoE status word. Object number 0x6041. If bit 11 is set in the status in the drive then we must see the same in DRIVE_STATUS. If not then the drive is not setting the bit in Object 0x6041. You can check the object ...