AN-282 Recovery from a failed system software load
Some Motion Coordinators have a built-in boot loader which can be used to aid recovery in the event of a failed system software load.
This application note applies to using the boot loader in the MC302X, MC403, MC405, MC464, MC4N-ECAT, MC4N-RTEX, and Euro404/Euro408.
Related Articles
MC6N Recovery
The MC6N has a recovery method if the firmware does not boot. Follow section 9.2 from Application note: AN282
Recovery SD card file name
When recovery of a Motion Coordinator with the recovery boot system, a special file name is used for the firmware file on the SD card. Go to the Trio website www.triomotion.com, log in and go to the Software->All Firmware page. Select the firmware ...
MC_CONFIG vs Flash parameters
All Motion Coordinators store the IP_ADDRESS, IP_NETMASK and IP_GATEWAY in Flash memory. So there is usually no need to add them to the MC_CONFIG. There are some differences with other system parameters. MC4N-ECAT, MC4N-RTX, MC6N-ECAT, Flex-6 Nano ...
AN-356 Firmware update procedure for UNIPLAY HMI
Uniplay 10' (P844) Human Machine Interface may be returned to us with corruption of the Flash that either causes the system to halt or prevents booting altogether. It is also possible if an update has not been interrupted or was not successful that ...
AN-342 Error during loading firmware
When installing a new firmware version, the process has two main steps. Firstly, the firmware file is downloaded on to the RAM memory and after that, the firmware is installed from RAM into the flash memory. If for any reason the power from the ...