AN-366 MODBUS TCP response time
When planning a network and the communication links between devices, the available response time is often needed to allow the system designer to work out how much data can be transferred.
This document lists the results of some timing tests on MC4/5/6 range Motion Coordinators with Ethernet ports supporting the Modbus TCP protocol.
Related Articles
AN-375 Trio PCMOTION ActiveX Ethernet Response time
When planning a network and the communication links between devices, the available response time is often needed to allow the system designer to work out how much data can be transferred. System critical data may need to be written or read in a known ...
Modbus TCP and Ethernet IP on Flex-6-Nano
Q. Can we run and use Modbus TCP server and Ethernet IP server on Flex-6-Nano at the same time? A. Yes you can use both in parallel. They open different "port" numbers on the Ethernet communications but have the same IP Address. For example Modbus is ...
Trio - Modbus TCP Client
The Trio firmware can open a Modbus Client port and communicate with any Modbus Server. Port number is usually 502. You need to have the document from the slave vendor that lists the register numbers in the Modbus connection of the device. Probably ...
Flexslice Loading/Configuration Limits - EBUS Load
EBUS loading of the the Flex-6 Nano and the Flex Coupler (P366) is limited to 16. Attached is a spreadsheet to calculate your projects requirements and highlight any possible limitations.
AN-326 Connecting to TCP/UDP client
It is possible to open one or more communication channels with remote devices using the TCP and UDP protocols via the controller’s main Ethernet port. This document explain and provide example of doing this