AN-301 PWM Output control

AN-301 PWM Output control

PWM outputs are required for laser control and similar applications. This document defines the functions available on the MC405 or similar controller for PWM.

Below functions are now supported:
- Programmable Mark/Space PWM outputs.
- Optional linking of PWM outputs to velocity profile speed of an interpolating axis group.
- Ability to define a PWM output intensity profile which can be linked to distance along an XY profile.
- Gating of PWM signal with sequence of positions on axis.

Other PWM control options are possible. Contact Trio if you need further functionality.


    • Related Articles

    • AN-329 PWM output control for Laser fire with ATYPE 36

      PWM outputs are required for laser control and similar applications. This document introduces a new ATYPE which has been created to allow accurate switching of a PWM output at equip-spaced points along an XY path. - Programmable Laser ON time ...
    • Pulse Train Output

      A (pulse) is on pins 1 and 2. B (direction) is in pins 3 and 4. PWM output when enabled is on pins 6 and 7. There are a couple of application notes about PWM: AN-301 PWM Output control AN-329 PWM output control for Laser fire with ATYPE 36
    • MC_CONFIG vs Flash parameters

      All Motion Coordinators store the IP_ADDRESS, IP_NETMASK and IP_GATEWAY in Flash memory.  So there is usually no need to add them to the MC_CONFIG. There are some differences with other system parameters. MC4N-ECAT, MC4N-RTX, MC6N-ECAT, Flex-6 Nano ...
    • virtual output

      Q: How do I used a virtual output? How can I read the state of the virtual output? A: Set virtual output with OP. Read virtual output with IN. OP(24,ON) IF IN(24)=ON THEN PRINT "OK" ENDIF
    • LinMot latest Drive support DS402 homing & Torque control

      LinMot have updated their firmware to include Position, Speed & Torque control now. The respective CoE objects are mapped in the fixed PDO profiles. The below LinMot Drives with Firmware 6.10 able to support this profiles In the attached EC_EXTEND, ...