3D Visualisation Example with Motion Perfect Gantry Sample Machine

Axis assignment

• Related Articles

• Will processes change with Motion Perfect 5?

  Process numbering is controlled entirely by the firmware so nothing should change when you update Motion Perfect.  For example, process numbers for MC405 are 0 to 9.

• MC202 controller and Motion Perfect

  For the MC202 you must use Motion Perfect 2. Motion Perfect versions 3, 4 and 5 are for the later generation of Motion Coordinators that connect using Ethernet. I am running this version of Motion perfect 2 on my Windows 10 PC. You need a COM port on ...

• Can I use Motion Perfect v4 with the new MC404-Z?

  The MC404-Z and other new products require the latest version of Motion Perfect to run them.  At the time of writing this post, the latest version is MPv5 version 5.0.2 and that is the recommended version for programming the MC404-Z 4 axis stepper ...

• Motion Perfect problem when SCOPE command is used

  When running the SCOPE command in a program, I think Motion Perfect doesn't like the SCOPE command being issued over and over when I run it. It seems more stable when I comment the SCOPE command out after it's ran once. ...

• Motion Perfect terminals - cursor control

  From Motion Perfect v4 version 4.4.1 onwards, the terminals 0, 5, 6 and 7 support a sub-set of the VT100 cursor control codes.  These are in the form of escape sequences starting with the <ESC> code ASCII code 27 ($1B in Hex) Currently supported ...